Hi Epifan,

I read in another post that there are command-line switches to set the state
of ecuEdit before it runs. The two switches mentioned were -ssm and -dash.

An educated guess would also suggest -mut, -obd, -data

If possible, could you please provide the full list of switches and their usage.

Thanks

Yes, this would be extremely helpful to have a full list of command line switches!

Command line swithces
ecuEdit.exe [logfilename.csv]... [ecufilename.hex]... [-ssm] [-mut] [-obd2] [-dash] [-custom_dash] [-full_screen]

-ssm - start Subaru logger
-mut - start Mitsubishi logger
-obd2 - start OBD2 logger
-dash - open logger with Dash page active
-custom_dash - open logger with Custom Dash page active
-full_screen - open logger in Full Screen mode

Outstanding!

Now we can all setup custom shortcuts to open and run ecuEdit in any desired preset configuration.

Thanks epifan for passing this on.


Cheers