Do you have a list of supported vehicles...??

Can ecuedit perform flashing, if not what program does it use to flash the rom??

Does it specifically support ADM MY00 GC8 (classic) Subaru WRX??

di_pietro11 wrote:Do you have a list of supported vehicles...??

Subaru Turbo 2001+ for logging, editing
Mitsubishi Evolution 6+ for logging, editing

di_pietro11 wrote:Can ecuedit perform flashing, if not what program does it use to flash the rom??

Not yet
You can use EcuFlash for reading/writing ROM

di_pietro11 wrote:Does it specifically support ADM MY00 GC8 (classic) Subaru WRX??

Only for editing, (may be for logging, I did not try to connect)
Look at this thread
http://forums.openecu.org/viewtopic.php?t=192
You can find some XML descriptions and Roms

It does log MY99/00 Euro spec and JDM Imprezas, but the pull down list of Advance Multiplier and Engine Load values are missing the addresses for these vehicles.

Not sure if they are in the XML or hard coded, I'll have a look later.

Andrew...

epifansoft, when you say it can edit the MY00 GC8 does that mean it can read roms from this model - ie: does a definition file for this model already exist for your program....... And if it does how did you get the roms to implement this as none of the current free programs support flashing for this model??? cheers

http://forums.openecu.org/viewtopic.php?p=3289
http://forums.openecu.org/viewtopic.php?p=3479
http://forums.openecu.org/viewtopic.php?p=3484
http://forums.openecu.org/viewtopic.php?p=8594

I've successfully used ecuEdit with a '98 Mitsubishi Legnum (Galant) VR-4. Used Openport 1.3 Mitsi cable, but it was necessary to ground pin 1 on the OBD socket before it could connect to the ECU.

aDe